This map of the Cranbourne Shire and various boundaries is from
The Good Country: Cranbourne Shire by Niel Gunson
We have a collection of aerial photographs of this area, which we recently lent to Frankston Library and they have digitised the images and put them up on Flickr - you can access them by clicking on this link.
https://www.flickr.com/photos/39368267@N02/sets/72157633269098525
Here are a few of these aerials, from 1970, when most of these areas were still undeveloped.
Carrum Downs 1970 - starting from the top - is Wedge Road - it goes across to the edge of the aerial - the Carrum Downs Recreation Reserve can be seen on the top left. The road on the left side of the photo, running at right angles from Wedge, Road is Cadles Road - it has a bit of a dog leg - this road is Brunnings Road and then Cadles Road continues down to Hall Road. The Road (just right of centre) that intersects Wedge Road and Hall Road and runs north south is McCormicks Road.
Langwarrin 1970 - this is the L-shaped Langwarrin Flora and Fauna Reserve. This Reserve was originally the Langwarrin Military Reserve. The road to the left of the Reserve is McClelland Drive; the arch on the left is the railway line that runs to Baxter Railway Station which is a junction station (which is why Baxter Railway Station was originally known as Mornington Junction Railway Station). The Baxter to Hastings line opened in September 1889 and reached Stony Point in December 1889. The other line used to run from Baxter to Mornington with stations at Mooroduc, Mornington Racecourse and Mornington. It also opened September 1889 and it closed June 1981.
Syke, Carrum Downs and Langwarrin 1970. The road running from left to right (or west to east) at the top is Hall Road. The road running down the centre of the photograph (north to south) is McCormicks Road. It intersects with Ballarto Road, towards the bottom of the photo. The two roads running off Ballarto Road are McClelland Drive on the left and Potts Road on the right.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.